|
|
Set the Sound AlarmThis example shows the procedure for enabling the sound alarm. Good if using just one camera. In Video Mode, with some video being displayed. Select menu item, Settings, Multiple Camera Scanning, clear check mark from Enable Scanning, and Show All Cameras Window. Select menu item, Settings, Alarms, Define Alarm Condition, place a check mark beside, Total All Cameras, and clear all check marks from cameras 0-7. Enter detected frames equal 10 beside Total All Cameras. Enter Time Interval equal 30, click OK. (if you get a warning message click OK). Select menu item, Settings, Alarms, Enable Sound Alarms, enter 15 in the field - For a Period of (seconds), and check Enable Play Sound on Alarm Condition. Click OK. ( Also make sure menu item, Monitor, Activate Enabled Alarms and
Capture, has already been selected i.e. status bar shows ARMED.) Select menu item Monitor, Monitor Start. Wave hand in front on camera for about 30 seconds. Result: The alarm sound starts to play for 15 seconds - looping continuously. Do the above again but this time, when the sound is playing select menu item, Settings, Alarms, Stop Sound Alarm. Result: The playing of sound stops immediately. Note: the play alarm sound is still enabled. Select menu item, Settings, Alarms, Enable Sound Alarms, uncheck Enable Play Sound on Alarm Condition. Click OK. (Alternatively, select menu item, Monitor, Deactivate Enabled Alarms and
Capture.) Result: The Play Sound Alarm feature has been disabled.
|
|
Video Surveillance WebCam Software by FG Engineering |